Tu.4.I
D01 - Steel and Alloys

Tu.4.I.1
  Full Paper

Brittle Failure Analysis of High-Burnup PWR Fuel Cladding Alloys

K. Simbruner1, M.C. Billone2, U. Zencker1, Y.Y. Liu2, H. Völzke1

1: Bundesanstalt für Materialforschung und -prüfung (BAM), Berlin, Germany
2: Argonne National Laboratory (ANL), Lemont, USA

Tu.4.I.2
  Full Paper

Vibration crack corrosion - a phenomenon that could promote the occurrence of increased oxide layer thicknesses in the upper region of fuel rods made of M5 cladding tubes

V. Böhm1, J. Müller1, T. Petersmann1, W. Hienstorfer2, B. Gerold1

1: TÜV SÜD Energietechnik GmbH Baden-Württemberg, Mannheim, Germany
2: TÜV SÜD Energietechnik GmbH , Filderstadt, Germany

Tu.4.I.3
  Full Paper

Annealing-temperature Evaluation of Type 316 Stainless Steel Based on Material Tensile Test

N. Yanagida1

1: Hitachi, Ltd., 7-1-1, Omika, Hitachi, Ibaraki, Japan

Tu.4.I.4
  Full Paper

Evaluation of the Fatigue Life of AISI 347 Specimens with Small Notches Based on Local Strain Considerations

K. Heckmann1, J. Sievers1, R. Acosta2, C. Boller2, T. Schopf3, T. Bill4, P. Starke4, L. Luecker5, K. Donnerbauer5, F. Walther5

1: GRS, Cologne, Germany
2: Saarland University, Saarbrücken, Germany
3: MPA University of Stuttgart, Stuttgart, Germany
4: WWHK, University of Applied Sciences Kaiserslautern, Kaiserslautern, Germany
5: WPT, TU Dortmund University, Dortmund, Germany

Tu.4.I.5
  Full Paper

Study of VVER-440 reactor pressure vessel weld metal after 45 years of operation

K. Medvedev1, A. Chernobaeva1, D. Erak1, D. Zhurko1, V. Kochkin1, N. Pal1, A. Reshetnikov1

1: NRC Kurchatov Institute, Moscow, Russia